Caldwell 309713 매뉴얼 - 페이지 3

{카테고리_이름} Caldwell 309713에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Caldwell 309713 4 페이지. Dual spinner target

USAGE INSTRUCTIONS:

The Caldwell Magnum Dual Spinner Target is made of Certified AR550 Through-Hardened Target Steel. This steel is

extremely durable and is designed to hold up to years of use.

In order to maximize the life of this product, follow the recommendations below:

• Lead and copper jacketed bullets are recommended. Solid copper or non-expanding bullets will accelerate wear on

the Spinner Target. (No Armor Piercing or Incendiary bullets should be used)

• The maximum IMPACT velocity of the bullet should be below 3000 feet per second.

• Maximum IMPACT energy of the bullet should be below 3100 lb-ft. (This target is NOT rated for .50BMG)

NOTE: Impact velocity and energy can either be obtained from the ammunition manufacturer or calculated using one

of the many ballistics calculators available on the internet.

• The Spinner Frame, Shaft and Fasteners are not intended to withstand direct bullet impact.

• If the surface of the Spinner Target becomes deformed, it can be turned around to provide a longer life. When

reassembling target, use high-strength thread locking adhesive and tighten bolts to 100 ft-lbs.

• Repainting the Spinner Target after shooting is not necessary but can be done to resist corrosion. The Spinner Target

can also be painted different colors to provide maximum contrast against a crosshair or open sights.

ASSEMBLY INSTRUCTIONS:

Thank you for purchasing a Caldwell Magnum Dual Spinner Target. Assembly of this product is very easy and requires

only a 19mm wrench or socket for the M12 hardware or an adustable wrench may also be used. Please take a moment to

locate all of the parts shown in the photo below. See Photo 2.

We continually strive to improve our products. In some situations where improvements have been made, the actual

product may vary slightly from these instructions

Photo 2

Photo Qty.

Description

Spinner Target Assembly (1021175)

Spinner Frame Leg (1012210)

Spinner Frame Upright (1018390)

Spinner Shaft (1017346)

Spinner Shaft Bushings (1018376)

Stakes (1016754)

Hardware Pack (1018625) Contains:

Photo Qty.

Description

1/4-20 Thumb Screws

E-Clips

Retaining Pins