FIREtec FTEP SERIES 설치 지침 및 사용자 설명서 - 페이지 10

{카테고리_이름} FIREtec FTEP SERIES에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FIREtec FTEP SERIES 16 페이지. 1-8 zone fire panel

When entering Level 3

Start at ZONE LATCH – Each zone is

individually set as either Latching or Unlatching.

Starting with Zone 1 led flashing (zone 1 is latching)

PRESS Key 2 (Change Setting) – moves flashing

Led to make 'Zone 1 UNLATCHING'

PRESS Key 1 (Function) – moves setting (flashing

led) to the next zone.

Repeat above process to set remaining zones.

On the last zone, Press Key 1 (Function) moves

setup to setting the Zone Type – 470R or Short CCT.

Zone Type – The fire detection type of each zone

is set as either 470R or Short Circuit

(default setting is 470R)

Starts at Zone 1 led flashing (Zone 1 is 470R)

PRESS Key 2 (Change Setting) – moves flashing

led to make 'Zone 1 Short CCT'

PRESS Key 1 (Function) – moves setting (flashing

led) to the next zone.

Key 2 -change setting to 470R or Short CCT.

Repeat above process to set remaining zones.

On the last zone, press Key 1 (Function) moves setup

to setting Monitor Input.

Setting Monitor Input – This is an input that when

set up requires 24Vdc applied to the terminal. If not

a fault is generated and the 'common fault' LED

is illuminated.

Monitor input can either be ON or OFF – if it is off

the input is not monitored and 24Vdc does not have

to be applied to the terminal.

PRESS Key 2 (Change Setting) – moves flashing

led to make Monitor Input either ON or OFF.

PRESS Key 1 (Function) – moves setting (flashing

led) to Class Change.

Setting Class Change – Set up to illuminate the

'common fire' led when Class Change is activated.

It can be set to either ON or OFF – if it is set to OFF

The 'common fire' led is NOT illuminated when

Class Change is activated.

PRESS Key 2 (Change Setting) – moves flashing

led to make option either ON or OFF.

PRESS Key 1 (Function) – moves setting (flashing

led) to Alarm Delay.