Firetide HotClient 2100 하드웨어 설치 매뉴얼 - 페이지 3

{카테고리_이름} Firetide HotClient 2100에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Firetide HotClient 2100 11 페이지. Customer premises equipment

Chapter 1. Setting Up Your Equipment

Introduction

Unpacking and Setup - Indoor

Figure 1. Series 2100 Indoor Unit - Package Contents

Figure 2. Indoor Unit Important Points

December 2007

The Firetide Model 2100 and 2200 HotClient Customer Premises Equipment (CPE) provide connec-

tivity to the Internet without the need for cable, DSL, or other wired connection. The HotClient

uses a radio connection to provide Ethernet-equivalent connectivity in your home or business.

You connect to the HotClient via a wired Ethernet connection. You can connect a single computer

or multiple devices on a LAN. You can also connect an 802.11 a/b/g/n access device, if desired.

Setup of your new Firetide HotClient is simple. The package contents are shown in Figure 1.

Your HotClient needs power. Note that the AC adapter has interchangeable inserts to fit most AC

receptacles in the US, Europe, the UK, Australia, and elsewhere. The adapter will operate on any

voltage from 100 to 240 VAC, from 50 to 60 Hz.

Your Firetide equipment needs to connect via a standard Ethernet (RJ-45) cable to your computer

or home network. Pick a suitable location for the device, and use the supplied power supply to pro-

vide power to the unit. The Power LED should illuminate immediately. Attach the supplied antennas

to the two antenna connectors. Tighten them firmly, by hand, and point them vertically.

Antenna 1

Ethernet

The Firetide device needs about two minutes to boot itself and then find the wireless signal. When

it completes this process, the Status LED will turn green.

Power

Reset

Antenna 2

Firetide Instant Mesh Networks 3