Alcochem Hygiene UV-A MOBILE TESTER 사용 설명서 - 페이지 3

{카테고리_이름} Alcochem Hygiene UV-A MOBILE TESTER에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alcochem Hygiene UV-A MOBILE TESTER 5 페이지.

3. INSTRUCTIONS FOR USE:

• Plug the UV Mobile Tester into the Smartphone headphone jack (A).

Open the App on your Smartphone, then tap the [ON] button on the

screen.

• For best results, prevent any vibrations. Ensure that the UV-A lamp being

tested has been switched on for at least 10 minutes to allow it to reach

its full UV-A output potential.

• Place the white sensor head in direct contact with the surface of the

UV-lamp (B). Taking a measurement at a distance from the lamp will

provide an incorrect reading since the sensor signal will diminish over

distance. It is recommended that the measurement is taken in the centre

of the lamp with the sensor head held flush to the lamp surface.

By sliding the lamp over the lamp surface, small variations in the lamp

strength can be seen. This is a normal phenomenon. For a more accurate

measurement take 3 measurements and use the average value found.

• The UV Mobile Tester works by plugging into the headphone jack and

cancels the phone volume control.

If making a call, or answering an incoming call, the UV Mobile Tester must be

disconnected.

• Incoming calls received while taking a measurement may affect the result.

Complete the test after taking the call.