Alcohawk AlcoHAWK ABI 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Alcohawk AlcoHAWK ABI에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alcohawk AlcoHAWK ABI 18 페이지. Digital alcohol detector
Alcohawk AlcoHAWK ABI에 대해서도 마찬가지입니다: 소유자 매뉴얼 (9 페이지)

Operating Instructions

WAIT 20 MINUTES AFTER SMOKING, EATING, OR DRINKING
BEFORE USE. FAILURE TO DO SO CAN ALTER THE BAC READING
AND CAN DAMAGE THE SENSOR.
1) Press the ON/OFF power switch. The detector will start to count
down from 200 to 000 on the DISPLAY. This warm-up process prepares
the sensor and circuit for testing.
2) When you hear a BEEP and the green READY light comes on, take a
deep breath, then blow steadily and continuously into the BREATH PIPE
until you hear another BEEP. You will be blowing for up to 5 seconds.
Your lips should be sealed around the mouthpiece while blowing. Be
careful not to cover the BREATH OUT opening on the unit. If you don't
blow within 30 seconds, the unit automatically displays "OFF". Press the
ON/OFF power switch to turn the unit off and repeat step 1).
3) After the red and green display lights blink for 4 seconds, the test
result will be displayed by 3 digits for 15 seconds. This number is your
estimated Blood Alcohol Concentration (%BAC).
- If the BAC reading is over 0.05%, the red WARN lamp will flash along with a BEEP
sound.
- If the BAC reading is over 0.40%, the display will read " HOT" and the red WARN lamp
will flash along with a BEEP sound. This can also occur if a subject blows alcohol from
their saliva into the tester.
- If you consumed very little alcohol, your actual concentration may be below 0.01%BAC
(Blood Alcohol Concentration), and the reading may not be activated. However, the
display will show 0.00%.
- If ErH is displayed, see the Error Messages section in this manual.

OPERATION

6