AERA ZQ 032 사용 설명서 - 페이지 6

{카테고리_이름} AERA ZQ 032에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AERA ZQ 032 12 페이지.

페이지 인쇄

1. Care and Maintenance

OPERATING THE DEVICE

• Never fill the water heater with cleaning

agents, oils, solvents, chemicals or other liquids.

Moreover, never add any cleaning agent,

fragrance or any other kind of additive to the

water. This could result in damage to the device.

• After filling the water heater, replace the safety

catch and secure in place by turning clockwise

again.

• The device must not be used without water. Risk

of overheating.

Using device for first time

• Connect the desired accessories to the handle of

the plastic hose.

• Open the safety catch of the water heater and

fill the reservoir with 500 ml of water. Please

be sure to observe all the instructions in the

"Filling/refilling water" section when doing so.

• Subsequently, screw the safety catch back

securely in place to the device.

• The safety catch must always remain securely in

place while the device is in operation.

• Ensure the device is always placed on a firm

and level surface. The device must not be

carried or tilted during operation!

• Plug the device into the power supply via a

suitable mains socket.

• Switch on the device, using the ON/OFF switch.

• The red heat indicator light indicates that the

device is heating up. The warming-up time

requires is approx. 8 – 10 minutes for cold

water. If filled with warm water, the time

required will be reduced accordingly.

• As soon as the device has attained the

operating temperature and the required steam

pressure, the green indicator lights up. The

device is now ready to use.

• Always ensure the steam nozzle outlet is

positioned in a safe direction. When starting

to clean, some water may also come out of the

nozzle.

• Direct the steam output nozzle onto the surfaces

to be treated, i.e. place the floor wiper onto

the surface to be treated and start the steam

treatment by pressing the steam delivery button.

30777-English_2 .indd 20

• In order to maintain the operating temperature

and the required steam pressure, the device

continues heating regularly during operation.

During this process, the red heat indicator lamp

lights up.

• The maximum operating time for the device is

40 minutes.

• When the amount of steam appears to decline

ever further while using the device, this is a sign

that the water heater is empty.

• Before opening the safety catch and refilling

the water heater, the device must be switched

off, unplugged from the mains and any steam

pressure remaining inside the device must be

released. To do so, press and hold the steam

delivery button for as long as steam continues to

escape from the device.

• Subsequently, allow the device to cool for at

least 15 minutes.

• Subsequently, open the safety catch of the

water heater.

• To reuse the device, refill the water heater again

with the maximum capacity of 500 ml of water.

• Subsequently, carefully secure the safety catch

back in place and proceed to operate as

described in the operating device section.

Switching off the device

• When you wish to shut down the operation,

switch off the device and unplug from the mains.

• To eliminate any remaining steam pressure

present in the device, press and hold the steam

delivery button until all the steam has escaped.

• Subsequently, allow the device to cool down for

at least 15 minutes.

• Afterwards, open the safety catch of the water

heater and completely empty the reservoir.

• Then shut the safety catch back securely in

place.

• Allow all accessories to dry thoroughly after use

and before stowing them away.

• When storing, wind the cord loosely around the

device. Be careful when doing so to ensure the

cord is not exposed to excess tension.

27/2/07 9:28:47 AM