Bad Elf Flex 사용자 설명서 - 페이지 4

{카테고리_이름} Bad Elf Flex에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bad Elf Flex 15 페이지.

● If you have not previously paired with this Bad Elf Flex, it will appear in the "Other

Devices" section. Tap the Flex in the list to start the pairing process. You may be

prompted to confirm the pairing on both your mobile device and

● Once you are paired, the Flex will appear in the My Devices section. If the status shows

as Disconnected, you can tap the Flex name to initiate a connection.

● Once the pairing and connection succeeds, you should see it listed as C onnected i n the

list of devices on your iOS device.

For Android phones and tablets

To pair the Flex with your Android device:

1. On your Android device, go to Settings > Wireless & Networks. Make sure Bluetooth is

turned on.

2. Go to Settings > Wireless & Networks > Bluetooth Settings and tap Scan for devices.

3. After a few seconds, the Flex should appear in the list of available Bluetooth devices.

4. Tap the name in the list and to start the pairing process. You may be prompted on both

your Android device and Flex to confirm the pairing.

5. Once paired, you usually see the Flex show up in the list as Connected for a few

seconds, before switched to Disconnected. This is normal. The Bluetooth connection

will be opened/closed by whatever apps are using it.

For Windows

To pair the Flex with your Windows computer please follow the instructions below. This process

will only have to be done once and does not need to be repeated in the future.

1. Select Bluetooth Devices from the icon list in the lower right hand portion of your

desktop.

2. Note, the Bluetooth option may not be displayed. If not click the up arrow.

3. If your Bad Elf accessory is turned on, you should see something like BE5500-12345678

(with your unit's serial number) in the list.

4. Select your Bad Elf receiver from the list, and tap the Pair button.

5. Within 5-10 seconds, you should see a prompt from windows showing pairing is

complete. Once this action is completed, the message "Ready to pair" will change to

"Paired" as shown below.

At this point you have successfully paired your Bad Elf receiver with your Windows computer.

Next, you will need to determine the COM port assigned by the operating system. To

accomplish this:

1. Click on the icon to the left of the Bad Elf GPS #XXXXXXX

2. Click on "More Bluetooth Options"