AlcoMate Revo TS200 운영자 매뉴얼 - 페이지 5

{카테고리_이름} AlcoMate Revo TS200에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AlcoMate Revo TS200 9 페이지. Digital personal breathalyzer

- Device Setup and Operation -

1. If batteries are not already installed, remove the rear cover of the device using the method

described on the previous page, then insert two 1.5V AAA batteries (included) into the battery

slot.

2. Snap the rear cover back in place.

3. Press and hold the power button to see the current cumulative test count in the screen;

releasing the button begins the warm-up countdown.

4. Wait for the display to show "blow".

5. You are now ready to test. Please insert a mouthpiece into the mouthpieces slot.

6. Blow sharply into the device until you hear the first audible click and continue to steadily

blow until you hear the second audible click, which signals that sampling is complete. You

should continue to blow more than 3 seconds until you hear the second audible clicks.

7. After a successful sample, the device will analyze the sample for a few seconds (you will see

the digit 0 move back-and-forth in the display).

8. Your reading will be displayed on the screen in g/dL ("%BAC"). While the result is being

displayed, you will see the "WAIT" indicator light on and also hear a short series of beeps.

9. The device will shut off automatically within 15 seconds, showing "Out" in the display.