AlcoMate Alcoscan AL2500 운영자 매뉴얼 - 페이지 4

{카테고리_이름} AlcoMate Alcoscan AL2500에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AlcoMate Alcoscan AL2500 8 페이지. Digital personal breathalyzer

- Device Setup and Operation -

If you are using the AlcoScan AL2500 for the first time, please install two 1.5V AA batteries (included) by

opening the rear cover of the unit.

Power On/Off

a) Press and hold the Power Switch to turn the unit on. The cumulative test count will be

displayed as you hold the Power Switch down.

b) Release the Power Switch. There will be a countdown from

The warm up process takes less than 30 seconds. The unit will play two (2) short BEEPS when it

is ready for use.

Breath Sample

: The user should take a deep breath and exhale sharply and steadily into the sensor

opening (above the display) for at least 3 to 4 seconds.

a) After you blow into the unit, it will BEEP once to show that it has taken a reading.

b) The unit will BEEP again when it starts analyzing the sample. You will also see a "WAIT"

indicator flashing in the display.

c) When the analysis is complete, the "WAIT" indicator will turn off and the unit will BEEP again.

You will then see a Blood Alcohol Concentration (BAC) reading in the display.

d) If a sample is not taken within 20 seconds, you will hear four (4) beeps and the unit will shut

itself off. (You can also press the POWER button again to manually shut off the unit.)

Analysis and Display

measure of Blood Alcohol Concentration (BAC) from 0.00% to 0.40%. The BAC will be displayed for 15

seconds. The unit will shut itself off after testing.

If you would like to perform another test, please power on the unit again. When performing multiple

tests, the warm up cycle shortens to less than 20 seconds.

Results

: The legal limit for intoxication (DUI/DWI) is 0.08% BAC across most of the USA. According to the

American Medical Association (AMA), a BAC of 0.05% is enough to impair the ability to drive. You should

never operate a motor vehicle when you are impaired by the consumption of alcohol, drugs or lack of proper

rest.

Measured BAC

Your Reading

0.00% to 0.01%

0.02% to 0.04%

0.05% and over

* Drinking alcohol in ANY amount may impair the ability to drive. There is no "safe" level of

alcohol intake before driving. Don't drink and drive.

: Once the sample is analyzed, the unit will display the result as a percent

Your Range

Safe* range

Moderate* range

Warning* range

as the unit warms up.

Description

Little/no alcohol intake.

Increased alcohol intake.

Ability to drive may be impaired.