3Com IntelliJack NJ200 소프트웨어 설명서 - 페이지 3

{카테고리_이름} 3Com IntelliJack NJ200에 대한 소프트웨어 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com IntelliJack NJ200 7 페이지. Network jacks
3Com IntelliJack NJ200에 대해서도 마찬가지입니다: 보충 설명서 (14 페이지), 데이터시트 (4 페이지)

페이지 인쇄
3Com IntelliJack NJ200 소프트웨어 설명서
3 C O M
®
N J 2 0 0 N E T W O R K J A C K — S N M P T R A P S

Configuration and Setup

The 3Com Central Configuration Manager GUI
enables point-and-click remote administration of
NJ200 Network Jacks.
3Com NJ200 Network Jacks come bundled with 3Com Central Configuration Manager.
Designed for in-depth configuration and remote management of these devices, this tool
can be installed on a standalone PC or in the same system as the network management
platform. NJ200 switches use SNMP Version 1 (RFC-1157) and support four standard
SNMP traps: link up, link down, cold start, and authentication failure.
To enable and configure SNMP traps on an NJ200 Network Jack:
1. Open Central
Configuration Manager
locate the NJ200 Netowrk Jack to be configured.
2. If the device is not on the initial list, begin a new discover
process by clicking on the
Discovery
3. Once the device has been located, select
four tabs. Clicking on the
SNMP Settings
and using either the IP or MAC address,
icon from the toolbar.
Device Property
to open a window with
tab opens a window that looks like this:
3