Ergo Systems 2000NB 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Ergo Systems 2000NB에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ergo Systems 2000NB 10 페이지.

Step 5

Insert the No Bark into the bracket that is fixed on the

wall.

SETTINGS

Push the TEST button to check if the unit is working.

Push the AUDIO-UP / ULTRASONIC - DW button to put the unit on AUDIO MODE where you will be able to hear the sound.

Push the AUDIO-UP / ULTRASONIC - DW button once again to set it in the ULTRASONIC mode, where the dogs alone will be

able to hear the sound.

Setting the sensitivity of the unit :-

There are three settings for sensitivity: Low, Medium and High. To place the unit on low sensitivity push the switch

to the bottom, the light underneath the on light should be off. This indicates that the sensitivity is set at low, which means

that it will only pick up barks that are close to the unit or loud. Pushes the switch up one notch the light should turn green

this is for medium sensitivity, this means that barks from a medium distance or a medium bark will be heard. Finally push the

switch to the top the light should now be red this is high sensitivity, which means barks from a further distance or softer bark

will be detected.

After setting the sensitivity level which is best for you, push the AUDIO-UP/ULTRASONIC-DW button again, this switches the

unit to the ULTRASONIC mode. Where the sound is audible only to dogs.

Fig 6

Step 6

Now the pin of 12v ac adapter needs to be inserted at the

provision provided at the bottom of the No Bark and the

adapter in turn is plugged into the wall socket.

Fig 7