Direct Healthcare Group Bure Rise & Go 기술 매뉴얼 - 페이지 8
{카테고리_이름} Direct Healthcare Group Bure Rise & Go에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct Healthcare Group Bure Rise & Go 12 페이지.
Direct Healthcare Group Bure Rise & Go에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)
페이지 인쇄
8. Maintenance
Recommended at least once per year.
Check that
General
The walker feels firm/free from play.
The walker does not rattle during manoeuvres.
The walker is level and all of its castors are in contact
with the floor.
The walker is not dirty.
Arm rests
Arm rests are intact and clean.
Arm rest widening is functional.
Handle
Grips are not damaged/dirty.
Handle adjustment is functional.
Battery
Check that the charging cable is connected to the
control box.
Check that the remote control is connected to the
control box.
Check that connections are made according to the
wiring diagram.
Check that the battery, actuators and control box
are not loose.
Height adjustment
Raising and lowering are functional.
The walker feels stable at maximum settings.
There is no play between the vertical frame and
bottom frame.
Height adjustment clamps lock.
The electric actuator fitting must be free from play.
Height adjustment via remote control is functional.
The electric actuator must run smoothly at a constant
speed.
Frame parts
There is no mechanical damage.
There are no scratches.
End plugs/lower frame fitted.
8
BU R E RI SE & G O
Action
Clean with lukewarm soap solution
(no petroleum products).
Clean; replace if damaged.
Replace lock knob.
Clean with lukewarm soap solution (no petroleum
products).
Replace handle grips.
Fit lock knobs/plates as required.
Fit new cable; this must always be connected to the
control box (IP65 classification).
Connect or fit new remote control as required.
Refer to the wiring diagram in the Technical manual.
Tighten; replace with new fasteners as required.
Fit new guide sleeves (in frame) or end plugs (in
chrome tubes) as required.
Tighten all lock bolts.
Replace clamps.
Tighten the attachment fitting concerned; replace
bolts/lock nuts as necessary.
Check that the battery/remote control/actuator are
connected in accordance with the wiring diagram.
Charge the battery. Contact customer services.
If damage is present, contact GATE's customer
services.
Touch up as necessary.
Fit new end plugs.
G ATE RD .SE