AERATE AC1320 매뉴얼 - 페이지 6

{카테고리_이름} AERATE AC1320에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AERATE AC1320 10 페이지. Cyclone/thunder

Install Pre-filter
Machine: Switch off purifier, if dust is accumulated, clean it with soft cloth soaked with
clean detergent water, and gently brush the inlet/outlet.
Filters: Filter replacement will be reminded by the inner machine automatically. Pre-filter
can be used for 2800hours, HEPA filter 2900 hours, activated carbon filter for
3000 hours.( Each filter can be used for about 1 year on 8 hour's running average
in account). However, with different using environment of different pollutants,
the cycle may differ. They can be replaced according to the running sounds or
smells changing smell. For new filters, please contact AERATE Service Center.
Remark: UV lamp installed
UV lamp: it can be used for about 2 years, while replacing it, you need to turn off the
machine, remove the UV lamp at 90 degrees rotation, and replace.
Sensor: It is a very sensitive optical sensor. After long time use, dust particles
will be accumulated to the lens surface of sensor. And then lower the sensor's sensitivity.
It is recommended as below pictures showed:
Please wipe the sensor with neutral detergent
Attention: Air purifier must be disconnected with the power supply before cleaning.
Clean with vacuum cleaner or
hot water
Use vacuum cleaner only
Dry in the sun for 1~3 hours