Clarion XR2220 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Clarion XR2220에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarion XR2220 18 페이지. Xr series amplifiers
Clarion XR2220에 대해서도 마찬가지입니다: 사용 설명서 및 설치 설명서 (10 페이지)

페이지 인쇄

1. Power and Speaker Connections

Setting the crossover

Clarion amplifiers feature fully-adjustable crossovers.

1. Using the X-Over mode switch, select either LP (low pass) or HP (high pass) or OFF for

full range.

2. Using the Freq (Hz) control, select the frequency.

Setting the bass boost

1. nitially set the bass boost control to off.

2. Listen to a variety of music styles (for example, rock, rap, etc.) and switch the bass

boost control on until you notice an increase in low bass response.

If you hear a pop caused by speaker overexertion, lower the bass

boost to prevent damage to the speaker.

Final system checks

1. Start the engine and turn on the source unit. (Please make sure vehicle is outdoors or

has adequate ventilation for exhaust fumes)

2. After a two-second delay, slowly increase the volume control and listen to the

audio.

If you hear any noise, static, distortion or no sound at all, check the connections and

refer to Troubleshooting. Depending on your system, the volume may become

quite loud even at low level settings. Until you get an "audio feel" for the system's

power, use care when adjusting the controls.

3. Turn the balance controls to their extreme positions and listen to the results. Audio

output should match control settings (audio from the left speaker when balance is left).

4. Increase the volume and verify that the amplifier reproduces the audio at full

frequencies without distortion.

If you hear distortion check the connections and verify that the gain control is set

correctly. Another cause of distortion could be underpowered or damaged speakers.

Refer to Troubleshooting.

XR2220/XR2420/XR2120

CAUTION