Alcorn Mcbride DMX OverRide 사용자 설명서 - 페이지 12
{카테고리_이름} Alcorn Mcbride DMX OverRide에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alcorn Mcbride DMX OverRide 12 페이지.
페이지 인쇄Troubleshooting Guide
Symptom
1) No Front Panel display
or LEDs
2) Previous scene not
restored after power is
cycled
3) Resume button keeps
flashing orange.
4) No DMX Output
5) Power LED is always
orange or blinking
Specifications*
DMX Standard – USITT DMX512/1990
Power – 5 VDC at 0.5 Amps max, AC Adapter included
Operating Temperature – 0°C (32°F) to 70°C (140°F), free air circulation
Operating Environment – 0-90% relative humidity, non-condensing
Size – 19" W x 1.75" H x 11" D (48.3 cm W x 4.4 cm H x 28 cm D)
Weight – 7 lbs, 3.1 Kg
Compliance – CE, UL, CSA, WEEE, RoHS
*Specifications are subject to change without notice
8
Troubleshooting Guide
Cause(s)
a) Input power not
connected.
b) Battery Dead or
disconnected
a) Scene selected by rear
inputs that are not in the
proper position.
b) Switch configuration
incorrect
a) It is possible that your
DMX input is dropping
out intermittently.
b) DMX input not
terminated.
a) Mis-wired or loose DMX
cables/connections.
a) Battery can no longer
be recharged or is
defective.
Solution(s)
a) Check Power connections
b) Replace or Connect Battery
a) Open scene selection input or
close it depending on switch
configuration
b) NO or NC verify switch
configuration
a) Check cabling. Check DMX
source.
b) Turn on DMX termination DIP
switch.
a) Confirm DMX connections are
secure.
b) Plug DMX input cable into
output cable to verify.
a) Please contact factory for a
replacement battery.