Direct Healthcare Group GATE EASY HighBack 사용자 설명서 - 페이지 6

{카테고리_이름} Direct Healthcare Group GATE EASY HighBack에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct Healthcare Group GATE EASY HighBack 12 페이지.

3. Battery charging

Charge the battery by connecting the charger supplied to a wall socket and

the remote control connector. A discharged battery takes around 12 hours

to charge to 80% and 24 hours to reach 100% charge. While the battery is

charging, the battery indicator will flash showing actual charge level. All three

bars will show a constant green light when the battery is fully charged. We

recommend the battery always be charged to at least 80% – once begun,

charging should not be interrupted before an 80% charge is achieved.

NOTE: The battery can be damaged if not charged at least every 14 days in

the On position or at least every three months in the Off position.

For safety reasons, chair electronics cannot be used while the battery is

charging. Avoid charging in wet spaces. Make a habit of always charging

the battery if at the end of the day it has dropped to level 1 (one green bar

on the battery indicator). If the hygiene chair will not be used for a few days,

we recommend switching off the battery by means of the Off button located

on the battery

Make sure the remote control socket/charge is always covered

plugged in when using the chair. Otherwise water may get in and

damage the remote control.

The battery is located under a protective cover at the base of the chair. The

battery has On/Off buttons that are reached through an opening at the lower

front part of the chair. Operate the buttons by pressing them with a pointed

object (not sharp). When delivered from GATE, the battery is switched off.

Activate the battery by pressing the On button or connecting the charger to

the remote control. To one side of the buttons, there is also an LED indicator

that shows battery charge.

We recommend using the handlebar whenever the chair must be moved

(with/without a patient). The handlebar is designed so that the chair can be

moved forwards and turned (see fig. 12) easily and with the use of little force

(see fig. 4).

Set the neck support in the desired position by sliding it up/down. Next

supports are available in other sizes as accessories.

The armrest is locked in the extended position. To lift the armrest, pull out

the pin (1) and raise the armrest (2).

EA SY HI GH BA CK

G ATE RD .SE