AlcoSense ZENITH+ 사용자 설명서 - 페이지 4
{카테고리_이름} AlcoSense ZENITH+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AlcoSense ZENITH+ 10 페이지. Industrial grade fuel cell breathalyser
페이지 인쇄Personal mouthpiece
The Zenith+ features a built-in permanent mouthpiece for personal use.
Push the hook to the side to extend the mouthpiece for personal testing.
To use a separate mouthpiece with the breathalyser, simply insert the
mouthpiece into the mouthpiece slot.
Warning Display
The breath sample was not strong enough to detect a reading. After
warm up, please blow strong and steadily into the mouthpiece.
The battery power is low. Please replace the batteries with new alkaline
batteries.
If you test over 1000 tests, the Zenith+ will display the CAL sign for sec-
onds before warming up. The CAL sign will provide the appropriate time
for calibrating the sensor.
System error – Please send the breathalyser back to the supplier for
repair.
System error – Please send the breathalyser back to the supplier for
repair.
Reading is over 0.200%BAC.
Recalibration & Service
The AlcoSense® Zenith+ uses a fuel cell sensor to measure breath alcohol
levels. Depending upon the amount of alcohol registered by the sensor after a
period of time, it will require recalibration.
Andatech recommends the AlcoSense® Zenith+ is calibrated every 6 months.
To maintain it to Australian Standards, calibration every 7 months is required.
Please visit my.andatech.com.au to register your breathalyser and book in a
calibration.