Direct IP DC-E Series 설치 매뉴얼 - 페이지 11

{카테고리_이름} Direct IP DC-E Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct IP DC-E Series 18 페이지.

Plug in the network cable.

Connect the plug terminal to the RJ45 jack.

Push the waterproof cap body and cap into the RJ45

jack and rotate it.

Lock the waterproof cap into the waterproof cap

body.

Not pulling the cable back may cause water to seep in

and damage the product.

Installation

• Check the wall or ceiling to see if it needs to be

reinforced. The camera may fall off if the wall or

ceiling is not strong enough to support its weight.

• Install the camera in a shaded area. If the camera

is installed in direct sunlight, it may be affected

adversely.

Screw the mounting bracket to the wall or ceiling by

using screws(4) and bushings(4) provided with the

camera.

Adjust the camera angle by bending the stand. After

fully assembling the joint screws, unscrew it 2 ~

2.5 turns again and move the cover of the joints of

the left 3 places slightly. (The screws should not be

completely released to prevent it from falling.) After

adjusting the direction of the camera, turn the screw

clockwise to secure it completely.

Screw

Part 1 – Introduction