Xerox 3270 프로그래머 매뉴얼 - 페이지 9

{카테고리_이름} Xerox 3270에 대한 프로그래머 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 3270 34 페이지. Xerox electronic documentation laser 3270 programmer's guide

3270 Programmer's Guide

Introduction

The settings can be downloaded as special commands from your

IBM system or from a PC to the Centronics or RS 232 (in case of

serial connector) input port. The converter uses these commands for

its own internal setup.

Initially, the settings can be downloaded to the temporary memory

area (see Chapter 3. Manipulation of Temporary and Permanent

Memory Areas) of the converter, where they take immediate ef fect.

The settings in the RAM area may be saved permanently in the

permanent memory area, if specified by a special command. The

permanent memory area is read each time power is turned on to the

converter or when you give a special command.

1.6. Serial Input/Output

NOTE:

This section only applies if your product is equipped

with a serial connector

The serial port can be configured as input or output.

SERIAL OUTPUT

For serial output , the FSL printer driver has to be used.

For details on this, please see doc. no. D62071.

SERIAL INPUT

For serial input , you can use both FSL and PCL printer drivers. For

details on serial input, please refer to relevant chapters in D62071

(FSL) and D62030 (PCL) for details.

- 9 -