Xerox 6180DN - Phaser Color Laser Printer 사용자 설명서 - 페이지 16

{카테고리_이름} Xerox 6180DN - Phaser Color Laser Printer에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 6180DN - Phaser Color Laser Printer 28 페이지. 26-ppm monochrome/ 20-ppm color
Xerox 6180DN - Phaser Color Laser Printer에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 사양 시트 (2 페이지), 사용자 설명서 (32 페이지), 설치 매뉴얼 (2 페이지), 보안 매뉴얼 (38 페이지), 릴리스 노트 (2 페이지), 설치 매뉴얼 (2 페이지), 시작하기 매뉴얼 (37 페이지), 매뉴얼 (34 페이지), 매뉴얼 (34 페이지), 시작하기 매뉴얼 (34 페이지), 사용자 설명서 (32 페이지), 설치 및 운영 매뉴얼 (8 페이지), 사양 (4 페이지), 매뉴얼 (28 페이지)

Xerox 6180DN - Phaser Color Laser Printer 사용자 설명서
Installation and setup

Printing a trace job within DocuSP IPS Manager

Printing a test job from the host

2-8
During the installation process, three sample DocuSP IPDS trace jobs
are provided. These jobs can be used to either verify printer
operability after the DocuSP IPDS software is installed or for
diagnostic purposes:
afptrace.let — prints a sample IPDS job formatted for US Letter paper
afptrace.a4— prints a sample IPDS job formatted for A4 paper
scfont.trc— prints a sample IPDS job using resident outline fonts
formatted for either US Letter or A4 paper.
In order for the trace scfont.trc to print correctly, the IBM AFP fonts
must be loaded on the printer and Enhanced Font Support must be
enabled.
NOTE: These jobs test only DocuSP IPDS processing on the printer.
The trace files are set up to use the installation default parameters. If
you plan to run the A4 trace instead of the US Letter trace, change the
Media Definition for the DocuSP IPDS Tray 1 from US Letter to A4. In
DocuSP IPDS, you must map a medium to each DocuSP IPDS tray
specified in the IPDS data stream.
For the installation verification jobs, use US Letter or A4 media. Refer to
the DocuSP IPDS on-line help for the specific procedures.
To verify host-to-printer communications, perform these steps to print
a test job from the host:
Step 1. Ensure DocuSP IPDS is running and is reporting a status of
DocuSP IPDS Idle.
Step 2. Start the logical printer from the host and verify that it is
active.
Step 3. Send an IPDS print data stream from the host to the DocuSP
Xerox DocuSP IPDS User Guide