Xerox 8200N - Phaser Color Solid Ink Printer 네트워킹 설정 매뉴얼 - 페이지 43
{카테고리_이름} Xerox 8200N - Phaser Color Solid Ink Printer에 대한 네트워킹 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 8200N - Phaser Color Solid Ink Printer 47 페이지. Phaser color printer
Xerox 8200N - Phaser Color Solid Ink Printer에 대해서도 마찬가지입니다: 사양 (4 페이지)
페이지 인쇄UNIX/Linux Network
This section provides installation and troubleshooting steps for UNIX and Linux:
I
Overview — see page 38.
I
Quick install steps — see page 38.
I
Additional resources — see page 39.
Overview
Your Phaser printer supports connection to a variety of UNIX platforms. Below is a list of the currently
supported versions:
I
Solaris
I
IBM AIX
I
Hewlett-Packard HP-UX
I
DEC UNIX
I
True UNIX 64 (Compaq)
I
Linux (i386)
I
Linux (PPC)
I
SGI
The procedures contained in this document enable you to connect your printer using any of the
supported versions of UNIX or Linux listed above.
Quick install steps
1.
Print the Configuration Pages and retain them for reference. For information on printing
Configuration Pages, see the Front Panel chapter of the Phaser 8200 Color Printer User Guide on
the Software and Documentation CD-ROM.
1.
Check the Configuration Pages and verify that both TCP/IP protocol and the proper connector are
enabled.
2.
Go to the section IP Address and perform one of the procedures there, depending on the manner in
which you want to set your printer's IP address.
3.
Solaris: Refer to the CentreWare Services for Unix Systems User Guide (English only) included
on the Advanced Network Management Tools CD-ROM for CentreWare installation and
detailed printer setup instructions.
Other UNIX OS: Load printer drivers and configure the printer for one of the Print Models.
These drivers are available on the Advanced Network Management Tools CD-ROM or from
the Xerox web site at www.xerox.com/officeprinting/support.
Copyright © 2002 Xerox Corporation. All Rights Reserved.
Phaser® 8200 Color Printer
38