Xerox 850DP - Phaser Color Solid Ink Printer 릴리스 노트 - 페이지 10

{카테고리_이름} Xerox 850DP - Phaser Color Solid Ink Printer에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 850DP - Phaser Color Solid Ink Printer 33 페이지. Installation guide for accxes 10.2
Xerox 850DP - Phaser Color Solid Ink Printer에 대해서도 마찬가지입니다: 사양 (2 페이지), 운영자 매뉴얼 (16 페이지), 보충 설명서 (1 페이지), 보충 설명서 (11 페이지), 설정 매뉴얼 (1 페이지), 청소 지침 매뉴얼 (9 페이지), 업그레이드 매뉴얼 (8 페이지), 보충 설명서 (26 페이지), 릴리스 노트 (11 페이지), 릴리스 노트 (11 페이지), 설치 지침 (2 페이지)

5 New Features of 10.3.3 b 106

Version 10.3.3 build 106 is intended to be a SPAR release for the HFT, and PUN controllers.

The following features were added as part of those SPAR fixes.

Versions of FreeFlow Accxes prior to 11.3 did not apply the Accxes contrast/lightness settings to

PDF or PostScript prints. These settings may now be used to adjust contrast and lightness on

PDF and PostScript prints.

The internal selection of tone curves and halftone screens for PostScript/PDF files has been

improved for certain document types

This allows users to control technical details of how PDF files are printed. All PDF files are

internally converted to PostScript for printing. This new selection (on the Postscript emulations

tab in WebPMT) allows a choice between conversion to PostScript Level 2 or PostScript 3. Prior

versions of Accxes had always converted to PostScript 3. Setting this selection to "2" may allow

certain files to print. However, it may also prevent other PDF files from printing; the default

setting of 3 should always be chosen unless specific PDF printing problems arise.

Support was added for the new releases of the following IOT firmware versions:

721:

6030/6050:

If 880mm paper is loaded and configured on the 6030/6050 it will be recognized by the FreeFlow

Accxes controller. The 880mm media will be displayed and used for printing and copying.

Page 10

01.05.00

4.1.06