Xerox DocuColor 5750 보충 설명서 - 페이지 6

{카테고리_이름} Xerox DocuColor 5750에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuColor 5750 10 페이지. Digital color printer / copier
Xerox DocuColor 5750에 대해서도 마찬가지입니다: 참조 매뉴얼 (8 페이지), 참조 매뉴얼 (7 페이지), 참조 매뉴얼 (7 페이지), 참조 매뉴얼 (9 페이지), 보충 설명서 (8 페이지), 서비스 매뉴얼 (40 페이지), 시작하기 매뉴얼 (46 페이지), 매뉴얼 (9 페이지)

• Single-Step Transfer (SST)—Special paper used to transfer full-color images directly from

copies or prints onto fabric or other types of materials.

• Labels—Adhesive-backed, pressure-sensitive label stock.

Color Mode

CMYK/Grayscale

The default setting for printing reﬂects the Color Mode speciﬁed in Control Panel

OTE

Setup.

• CMYK—Enables both Contone and Halftone Printer Mode options.

• Grayscale—Enables Contone Printer Mode option only.

The ACA 1 and ACA 2 settings are no longer available.

OTE

Sharpness

Softer/Normal/Sharper [Normal]

• Softer—Decreases the clarity of the printed image.

• Normal—No adjustment is made to the clarity of the printed image.

• Sharper—Increases the clarity of the printed image.

This option is available on MajestiK and Regal color copiers only .

OTE

Calibration/Simulation

Copier/SWOP-Coated/DIC/Euroscale/Linear/Custom-1/Custom-2/None [Copier]

Calibration/Simulation allows you to change the calibration curve currently set on the

Fiery XJ for the current print job only . As the job begins processing, the target selected in

Calibration/Simulation is loaded and applied before printing. Once the print job is

complete, the Fiery XJ returns to its previous calibration curve.

You are able to select targets that reﬂect those currently existing on the Fiery XJ. If you

select a target that does not exist, a PostScript error results and the job does not print.

• Copier—Uses the current copier calibration target set in Printer Setup on the Fiery XJ

Control Panel.

• SWOP-Coated—Uses the United States press standard.

• DIC—Uses the Japanese press standard.

• Euroscale—Uses the European press standard.

• Linear—Divides the maximum measured density for each color into equal, linearized

density steps, providing an even distribution of tones over the copier's density range.

• Custom-1—Uses a custom calibration target. Before selecting this setting, you are

required to create a new target in Fiery XJ Print Calibrator and name the target

"Custom-1".

• Custom-2—Uses a second custom calibration target. Before selecting this setting, you are

required to create a new target in Fiery XJ Print Calibrator and name the target

"Custom-2".

• None—Disables calibration.

For more information about calibration, see chapter 6 of the User Guide .

Page 6