Xerox DocuColor 7000AP 릴리스 정보 - 페이지 32
{카테고리_이름} Xerox DocuColor 7000AP에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuColor 7000AP 36 페이지. European harmonic current notice
Xerox DocuColor 7000AP에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (26 페이지), 매뉴얼 (13 페이지), 공지 사항 (1 페이지)
페이지 인쇄
28
HCSS Front Staple Option Display
Spire Print Driver Software
Backup and Restore Configuration
Incorrect Print Status Information
On the
tab, under
Finishing
the
and
Stack Tray
Stapler
shown at an angle instead of straight. This is only a display issue. When the job is
sent to the stapler finisher, the direction of the staple will be straight.
There are limitations when using the Print Driver software in the following
applications:
•
Microsoft PowerPoint—for Letter or A4 paper sizes, set the paper size in
PowerPoint. Set all other paper sizes in the PPD file.
•
QuarkXPress—for Letter or A4 paper sizes, set the paper size in QuarkXPress.
Set all other paper sizes in the PPD file.
When using the above applications, before enabling the Print Driver software, go to
the Printer properties for the virtual printer and set the PPD page size to the
maximum size available.
Note: You can always use the PPD file instead of the Print Driver software. To use the PPD
file, disable the Print Driver software by selecting off in the Enable enhanced user
interface list. Refer to "Setting up the Print Driver Software"> on page 15, for more
information.
The configuration file can only be backed up to the default path,
C:\CXP8000\General\Configuration
If you are reinstalling the CX print server software or upgrading your CX print
server software version, your configuration file cannot be restored using the
option in
Configuration recovery
To restore your configuration file, after the CX print server software has been
installed, go to
Tools > Settings > Administration
Locate your configuration file and start the restore process.
The Printing status indicator becomes blank during a paper jam. It does not depict
the percentage or the number of pages that have completed printing.
Xerox CX Print Server 1.0 Release Notes
, when you select
Finisher options
options, the display of the
.
of the Configuration Wizard.
Step 1
, and select
and also select
HCSS
position for the staple is
Front
DFE
Configuration backup
.