Xerox DocuColor 8000 시작하기 매뉴얼 - 페이지 32

{카테고리_이름} Xerox DocuColor 8000에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuColor 8000 40 페이지. European harmonic current notice
Xerox DocuColor 8000에 대해서도 마찬가지입니다: 매뉴얼 사용 (2 페이지), 정보 게시판 (2 페이지), 정보 게시판 (1 페이지), 계획 매뉴얼 (22 페이지), 청소 절차 (2 페이지), 참조 매뉴얼 (4 페이지), 브로셔 (14 페이지), 운영 지침 (1 페이지), 매뉴얼 (10 페이지), 보충 설명서 (6 페이지), 매뉴얼 (13 페이지), 공지 사항 (1 페이지)

Xerox DocuColor 8000 시작하기 매뉴얼
G e t star te d no w !

How to Power On/Off the Digital Press

ON/OFF
ON
OFF

How to Load Paper

10
Use the Power Switch to power ON or power OFF the Digital
Press. It is located below the User Interface.
Press the Power Switch to the ON position to power ON
the Digital Press.
A screen message advises of a short wait while the
Fuser warms up and the Digital Press runs a system
check. You can program the Digital Press for a job
during this time and the printing process will start
automatically when the Digital Press is ready.
Press the Power Switch to the Off position to power off
the Digital Press.
Allow the Digital Press to remain off for a minimum of 10
seconds before switching the power ON again.
You can load a wide variety of coated or uncoated standard paper
sizes and weights into the Paper Trays, ranging from 7.2 x 10.1
inch (Long Edge Feed or Short Edge Feed) to 12.6 x 17.7"
(Long Edge Feed).
Acceptable weight ranges are from 60 to 300 g/m
range of the paper loaded is shown on the Machine Status screen.
Perform the following steps to load paper:
Pull out the Paper Tray slowly until it stops.
1.
Load the paper into the tray and refer to the orientation labels
2.
the tray.
Load the paper seam side (the side on which the ream of
paper is sealed) up in all the trays.
Do not load materials above the MAX line located on the
rear Edge Guide.
Do not store extra reams of paper in the open area of the
paper trays. The tray will become inoperable until the
paper is removed.
NOTE: Many suppliers use arrows on the paper ream labels to
indicate the preferred side to image first. Use this side (as
indicated by the arrow) as equivalent to the seam side when
loading the paper.
Adjust the Paper Guides by pressing in the guide release and
3.
carefully moving the Edge Guide until it lightly touches the
edge of the media in the tray.
Do c u Co l or 8 00 0 /7 00 0 G e t ti n g Sta r te d
2
. The weight