Xerox Phaser 8560 서비스 매뉴얼 - 페이지 6

{카테고리_이름} Xerox Phaser 8560에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 8560 30 페이지. 8580 series; 8880 series
Xerox Phaser 8560에 대해서도 마찬가지입니다: 사용자 설명서 (3 페이지), 평가자 매뉴얼 (19 페이지), 경쟁사 비교 (2 페이지), 빠른 사용 설명서 (5 페이지), 변동성의 편지 (1 페이지), 설치 매뉴얼 (2 페이지), 경쟁사 비교 (2 페이지), 브로셔 (27 페이지), 서비스 매뉴얼 (13 페이지), 설치 매뉴얼 (9 페이지), 빠른 사용 설명서 (6 페이지), 빠른 사용 설명서 (6 페이지), 빠른 사용 설명서 (6 페이지), 빠른 사용 설명서 (6 페이지), 빠른 사용 설명서 (6 페이지)

Symbols Marked on the Product

Power Safety Precautions

Disconnecting Power

Read and obey all posted warning labels. Throughout the printer, warning

labels are displayed on potentially dangerous components. As you service the

printer, check to make certain that all warning labels remain in place.

Use caution (or draws attention to a particular component). Refer

to the manual(s) for information.

Hot surface on or in the printer. Use caution to avoid personal

injury.

For 115 VAC printers, do not apply more than 135 volts RMS between the

supply conductors or between either supply conductor and ground. For 230

VAC printers, do not apply more than 254 volts RMS between the supply

conductors or between either supply conductor and ground. Use only the

specified power cord and connector. This manual assumes that the reader is

a qualified service technician.

Plug the three-wire power cord (with grounding prong) into a grounded AC

outlet only. If necessary, contact a licensed electrician to install a properly

grounded outlet. If the product loses its ground connection, contact with

conductive parts may cause an electrical shock. A protective ground

connection by way of the grounding conductor in the power cord is essential

for safe operation.

Warning

The power switch does not completely de-energize the printer. You must

also disconnect the power cord from the printer's AC inlet. Disconnect the

power cord by pulling the plug, not the cord.

Disconnect the power cord in the following cases:

■

if the power cord or plug is frayed or otherwise damaged,

■

if any liquid or foreign material is spilled into the product,

■

if the printer is exposed to any excess moisture,

■

if the printer is dropped or damaged,

■

if you suspect that the product needs servicing or repair,

■

whenever you clean the product.

Phaser 8400/8500/8550/8560 Color Printer Service Manual