Xerox XES Synergix 8855 사용자 설명서 - 페이지 5

{카테고리_이름} Xerox XES Synergix 8855에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox XES Synergix 8855 44 페이지. Engineering printer

Safety Notes

Your XES Synergix 8825/8830/8855 Digital Solution has been designed and
tested to meet strict safety requirements. These include safety agency
examination and approval plus compliance with established environmental
standards.
Please read the following instructions carefully before operating the XES
Synergix 8825/8830/8855 Digital Solution and refer to them as needed to
ensure continued safe operation.
Follow all warnings and instructions marked on or supplied with the product.
Unplug the units from the wall outlet before cleaning the exterior. Always use
materials specifically designated for the XES Synergix 8825/8830/8855 Digital
Solution. Use of other materials may result in poor performance and could
create a hazardous situation.
Do not use aerosol cleaners. Follow the instructions in this operator manual
for the proper cleaning methods.
Never use supplies or cleaning materials for purposes other than what they
were intended. Keep all supplies and materials out of the reach of children.
Do not use the units near water, wet locations, or outdoors.
The components of this product are equipped with a three-wire, grounding-
type plug (i.e., a plug having a grounding pin). This plug will only fit into a
grounding-type power outlet. This is a safety feature. To avoid the risk of
electric shock, contact your electrician to replace the receptacle if you are
unable to insert the plug into the outlet.
Never use a ground adapter plug to connect the system to a power source that
lacks a ground connection terminal.
This system should be operated from the type of power source indicated on
the marking label. If you are not sure of the type of power available, consult
your local power company.
The power supply cord is the disconnect device for this equipment. Make sure
that the installation is near the socket outlet and is easily accessible.
Do not allow anything to rest on the power cord. Do not locate the units where
someone will step on the cord.