Xerox 220 빠른 설치 매뉴얼 - 페이지 7

{카테고리_이름} Xerox 220에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 220 8 페이지. Scanning services
Xerox 220에 대해서도 마찬가지입니다: 빠른 설치 (1 페이지), 스캔 개요 (2 페이지), 시작하기 (48 페이지)

페이지 인쇄
Xerox 220 빠른 설치 매뉴얼
Installation Requirements:
•
Be sure that the DC220/230/332/340ST is
connected, configured and operational as a
Network Printer with NetWare enabled and
the correct Frame Type selected before
performing this procedure.
•
The DC220/230/332/340ST Scan To File
option kit must be installed before
performing this procedure.
•
Create a user account for the DC220/230/
332/340ST. Use NWADMIN for NetWare
4.x/IntraNetWare, to create an account on
the file server for the DC220/230/332/340ST
with all access rights to the document
Repository except supervisor.
Before Installation:
Please review the DC220/230/332/340ST
Scanning Overview card before proceeding.
For assistance, contact your local Xerox Customer Support Center
602E60410
7KH 'RFXPHQW &RPSDQ\
DC220/230/332/340ST NDS
Record the following information for use during
setup at the DC220/230/332/340ST:
Scan User Name:________________________
Scan User Password:_____________________
NDS Tree:______________________________
NDS Context:___________________________
File Repository Server:____________________
Repository Directory:_____________________
Note: Scan to File requires the typefull (or fully
distinguished) NDS syntax.
Example: cn=xxx.ou=xxx.o=xxx.c=xxx.
1.
Enter System Administrator Setups:
a)
Press the [Access] button on the
Control Panel.
b)
Enter the System Administrator
password by typing
and 22222) on the keypad and
pressing [Enter] on the screen.
Note: #22222 is the factory default
and may be changed by your Xerox
service representative to suit your
needs.
;(52;
Scan to File Quick Install
®
#22222
(# key
Page 1 of 2
2.
Access the Scan to File Setups screens
and assign the Default Repository Server:
a)
On the screen display, press [Scan to
File Setups].
Note: The Job Template Pool and Update All
Templates options on this screen are not used in
this environment.
b)
Press [Default Repository].
c)
Press [Netware].
d)
Press [Server].
e)
Press [Edit] and use the keyboard on
the screen to enter the name of the file
server.
f)
Press [Save].
3.
Assign the Default Repository Path:
a)
Press [Directory Path].
b)
Press [Edit] and use the keyboard on
the screen to enter the path.
Be sure to enter the full path,
including the volume name, to the
DC220/230/332/340ST account
directory.
Example: vol1:\users\scan.
c)
Press [Save].
Over