Xerox 3100MFPX - Phaser B/W Laser 사용 설명서 - 페이지 29
{카테고리_이름} Xerox 3100MFPX - Phaser B/W Laser에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 3100MFPX - Phaser B/W Laser 36 페이지. Dect phone installation instructions
Xerox 3100MFPX - Phaser B/W Laser에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 평가자 매뉴얼 (12 페이지), 설치 지침 (2 페이지)
![Xerox 3100MFPX - Phaser B/W Laser 사용 설명서](/uploads/products/server2/7033014/7033014.jpg)
S
ETTINGS
Select CHANGE CODE using
Valid.
.
Enter the old base code using the keypad
(default is 0000). Press Valid.
Enter the new base code using the keypad.
Press Valid.
.
Confirm by entering the new base code
again. Press Valid.
To exit the menu, press the red key
Carefully note down the base code
number. You will need this code to
change certain settings.
or
. Press
.
.
.
30
H
ANDSET SETTINGS
Registering a new handset to a
terminal
To register a new handset to a base you
must:
•
put the handset in registration mode,
•
put the base in registration mode.
Once this is done, the registration (mutual
recognition of the base and the new handset)
will be done automatically (registration can
take a few seconds).
Take the handset to be registered:
On the navigator key
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using
Press Valid.
.
Select SET HANDSET using
Valid.
.
Select REGISTRATION. Press Valid.
Press Yes
to put the handset in
registration mode.
The handset enters the registration mode.
, press
or
or
.
or
. Press
.