Xerox 3100MFPX - Phaser B/W Laser 사용 설명서 - 페이지 34
{카테고리_이름} Xerox 3100MFPX - Phaser B/W Laser에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 3100MFPX - Phaser B/W Laser 36 페이지. Dect phone installation instructions
Xerox 3100MFPX - Phaser B/W Laser에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 평가자 매뉴얼 (12 페이지), 설치 지침 (2 페이지)
페이지 인쇄
A
PPENDIX
Care and Maintenance
Use a slightly damp cloth to wipe the base and handset, do not use a dry cloth as this may
cause electrostatic charges.
Problems
Refer to the table presented below in case of an operational malfunction:
Problems
The handset display is blank
The handset does not ring
during an incoming call
No radio link between the
handset and base
The network indicator icon
flashes
You obtain a "busy" dial tone for
each dialled number
Remedies
Make sure the batteries are properly installed.
Place the handset on the base and fully charge the batteries.
To increase the life of your batteries, you can perform this operation about every
two months.
If these precautionary measures do not resolve this issue, replacement
batteries are available through your reseller.
As time goes by, you may notice a slight decrease in battery performance. Use
your handset until the battery is fully discharged, and then charge it for at least
12 hours.
Make sure that the telephone is properly connected and that you have a dial
tone.
Make sure your telephone is not set to silent mode (see pargraph Settings).
Make sure your terminal is in FAX-TEL mode.
Make sure the handset is registered by moving closer to the base, if it is
registered correctly, the handset screen should display its own handset number.
Otherwise, register the handset to the base. See "Registering a new handset to
a terminal", page 30.
Make sure no one else is using another handset (if the intrusion mode is
deactived).
35