Xerox 4150S - WorkCentre B/W Laser 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Xerox 4150S - WorkCentre B/W Laser에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 4150S - WorkCentre B/W Laser 38 페이지. Finisher installation guide
Xerox 4150S - WorkCentre B/W Laser에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 빠른 참조 (1 페이지), 카트리지 교체 (1 페이지), 설치 지침 매뉴얼 (40 페이지), 모듈 설치 매뉴얼 (1 페이지), 하드웨어 설치 매뉴얼 (1 페이지), 트레이 모듈 설치 매뉴얼 (1 페이지), 모듈 설치 매뉴얼 (1 페이지), 설치 매뉴얼 (6 페이지)

페이지 인쇄
Xerox 4150S - WorkCentre B/W Laser 시작하기 매뉴얼
8
The Machine Configuration screen asks you to confirm that the WorkCentre has correctly
recognized the Configuration that you ordered. If there are any errors, follow the
instructions on the screen. If the configuration is correct, select Next.
9
The Default Paper Size screen is displayed. Select either A4 or 8.5 x 11 inches and Next.
10
The Customer Support and Supplies Numbers screen is displayed. Enter the Customer
Support Telephone Number and the Supplies Telephone Number and select Next.
NOTE:
This is for reference only. You may leave these fields blank if you do not have the
information.
11
The next 4 screens will allow you to set the Date Format, Date, Clock Format and Time.
Follow the instructions to enter the appropriate information and select Next on each
screen.
12
The Set Greenwich Meantime Offset screen will be displayed.
Greenwich Mean Time (GMT) is World Time and is the basis for every world time zone. A
table of GMT Offset is included at the end of this book. Either locate the GMT Offset for
your location from the table, or access http://wwp.greenwichmeantime.com/ for addi-
tional time zones.
When you have input the GMT Offset select Next.
13
The Congratulations screen will be displayed. This indicates that you have successfully
completed the System Settings portion of the Xerox Installation Wizard. Select Finish to
continue.
NOTE:
In some locations a popup screen will appear asking for the Page Pack Passcode.
If this occurs, contact your Customer Support Representative for the passcode.
14
The machine will display a Machine self test in progress screen while the machine applies
the configuration settings. When this is complete the machine will display the Basic
Copying screen. Your WorkCentre is now ready for you to use.
getting started guide
5