Xerox 460 빠른 설치 매뉴얼 - 페이지 38
{카테고리_이름} Xerox 460에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 460 38 페이지. Macintosh driver information
Xerox 460에 대해서도 마찬가지입니다: 정보 매뉴얼 (13 페이지)
![Xerox 460 빠른 설치 매뉴얼](/uploads/products/server2/7033187/7033187.png)
Port 9100 TCP/IP Printing Quick Install Card
Xerox Document Centre 460/470 ST
6.
Set the Subnet Mask and Gateway.
a)
Press the Subnet and Gateway
button.
b)
Press the soft buttons on the Touch
Screen one at a time for each octet of
the Subnet Mask and enter the
numbers using the keypad. Repeat
this process for the IP Gateway
address. When finished press Save to
record the changes and exit to the
TCP/IP Settings screen.
NOTE: The Broadcast Address will be calcu-
lated automatically.
7.
Enable Port 9100 printing .
a)
Press the Port 9100 printing button.
b)
At the next screen press Enable then
press Save.
8.
Exit the Tools Menu
a)
Press the Exit Tools button.
Go to a workstation and...
1.
Create a test job and send it to the printer
with a workstation utility or through a
queue on your operating system that sup-
ports Port 9100 printing.
2.
Check your test job for quality and use the
problem solving section of the Document
Centre 460/470 Reference Guide for
resolving print defects.
3.
If your print job does not print, refer to the
troubleshooting section in the document
entitled Network Installation and
Troubleshooting Guide to correct the
problem.
4.
Repeat this Go to a workstation and...
procedure at each workstation that will
print to this printer or at other servers
where a queue has been created.
Page 2