Xerox CopyCentre C128 네트워크 매뉴얼 - 페이지 3
{카테고리_이름} Xerox CopyCentre C128에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox CopyCentre C128 50 페이지. Xerox copycentre c123: installation guide
Xerox CopyCentre C128에 대해서도 마찬가지입니다: 평가자 매뉴얼 (12 페이지), 브로셔 및 사양 (6 페이지), 설치 매뉴얼 (2 페이지), 스캔 매뉴얼 (28 페이지), 빠른 설치 카드 (2 페이지), 서비스 매뉴얼 (22 페이지)
페이지 인쇄
Quick Network Setup Guide
This guide includes instructions for:
■
Quick Network Setup (DHCP)
Quick Network Setup (Static IP)
■
Quick Network Setup (DHCP)
The System Administrator Guide contains detailed information about network setups. This document is
intended for setting up the network using TCP/IP. If using Novel IPX, see the System Administrator Guide
for setup procedures.
Prerequisites for Quick Network Setup Using TCP/IP
1.
Confirm that an existing operational network utilizing TCP/IP is available.
2.
Confirm that the Ethernet cable is plugged into the multifunction device and into an operational Ethernet
port on the network.
Note
The Ethernet cable is an RJ45 type and is not supplied by Xerox.
Configuring an IP Address via DHCP
On startup, the multifunction device defaults to DHCP to obtain its network configurations. A DHCP server
delivers an IP address, as well as other configuration settings to the device. If you use a DHCP server to
allocate an IP address to the device, then proceed as follows:
Procedure for Quick Network Setup Using TCP/IP
1.
Power on the device.
2.
Wait a minute or so while the device negotiates an IP address.
3.
Print the System Settings List.
a.
Select the Machine Status button on the device.
b.
Select
Print Report
c.
Print Mode
Select
d.
Select
Setting List - Common
e.
Press the Start button.
Copyright © 2005, 2004 Xerox Corporation. All rights reserved.
on page 1
on page 3
List.
Settings.
Items.
Xerox WorkCentre
Xerox WorkCentre
1
®
M123/M128/133
®
Pro 123/128/133