Xerox DocuPrint 90 계획 매뉴얼 - 페이지 19
{카테고리_이름} Xerox DocuPrint 90에 대한 계획 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuPrint 90 22 페이지. Tape client job submission guide enterprise printing system
Xerox DocuPrint 90에 대해서도 마찬가지입니다: 시작하기 (28 페이지), 보충 설명서 (48 페이지)
페이지 인쇄
Xerox Document Binder 120-D (DB120-D)
4. Xerox Nuvera 100 / 120 Digital Production System
Limitations
System Dependencies and Prerequisites
•
A Finisher Transport Module is required for in-line
connectivity to the printer.
•
Coated paper is functional with the 860mm input height but
not recommended for the 1021mm input height. However,
binding test could be done and binding strength
confirmed/checked before start of job/production.
•
When connected inline with a printer, the minimum binding
capacity is 2 sheets of 20 lbs (75 gsm) bond paper. (In walk-
up manual mode, the minimum binding capacity is 1 sheet
20 lbs (75 gsm) bond paper.
•
The DB120-D is compatible with 8.5 x 11" (A4 in Europe)
paper in weights ranging from 20 – 110 lbs (75 – 200 gsm)
bond and flush cut tabs.
Note: Weights above 32 lbs (120 gsm) should only be used as
covers, dividers or inserts.
Listed below are the dependencies and prerequisites for
installing the DB120-D.
•
The Finisher Transport Module is required for in-line
connectivity to the printer.
•
Currently, a Xerox Document Stacker 5000 must be installed
in-line with the printer and the DB120-D.
•
If the DB120-D is installed in-line with another Finishing
Device (such as a DS5000), the 1021 Height Kit must be
installed (unit is shipped with 860 Height Kit installed).
•
If there is a transition of an existing (stand alone or from a
different printer) DB120-D to a Nuvera Digital Production
System, the DB120-D will require an upgrade.
Note: In case the floor at the customer site is very uneven, it is
recommended that the Nuvera IOT is installed and leveled with a
Caster Leveling Kit (kit number 498K07900).
4-1