Direct power BM210J 안전 및 운영 매뉴얼 - 페이지 5
{카테고리_이름} Direct power BM210J에 대한 안전 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct power BM210J 17 페이지. 8 1/2" compound mitre saw
페이지 인쇄instructions for lubrication and changing accessories. Inspect tool cord
periodically and if damaged have it replaced by an authorised service facility.
Inspect extension cords periodically and replace if damaged. Keep handles dry,
clean and free of oil or grease.
15. Disconnect tools.
When not in use, before servicing and when changing accessories such as blades,
bits and cutters, remove the mains plug from the socket.
16. Remove adjusting keys and wrenches.
Make the habit of checking to see that keys and adjusting wrenches are hat keys
and adjusting wrenches are removed from the tool before turning it on.
17. Avoid unintentional starting.
Do not carry a plugged-in tool with a finger on the switch. Ensure switch is in the
off when plugging in.
18. Use outdoor extension leads.
When tool is used outdoors, use only extension leads approved for outdoor
use.
19. Stay alert.
Watch what you are doing. Use common sense. Do not operate tool when you
are tired or under the influence of drugs or alcohol.
20. Check damaged parts.
Before further use of the tool, a guard or other part that is damaged should
be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, free running of moving
parts, breakage of parts, mounting and any other conditions that may affect its
operation. A guard or other part that is damaged should be properly repaired
or replaced by an authorised service centre unless otherwise indicated in this
instruction manual. Have defective switches replaced by an authorised service
facility. Do not use the tool if the switch dose not turn it on and off.
21. Warning.
The using of any accessory or attachment, other than those recommended
in this instruction manual may present a risk of personal injury.
22. Have your tools repaired by qualified person.
This electrical tool is in accordance with the relevant safety requirements.
Repairs should only be carried out by qualified persons using original spare
parts, otherwise this may result in considerable danger to the user.
8
COMPOUND MITRE SAW
BM210J