Xerox WorkCentre Pro 657 수리 매뉴얼 - 페이지 2
{카테고리_이름} Xerox WorkCentre Pro 657에 대한 수리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WorkCentre Pro 657 4 페이지. Copying documents
Xerox WorkCentre Pro 657에 대해서도 마찬가지입니다: 설치 매뉴얼 (1 페이지), 사용자 설명서 (14 페이지), 보충 설명서 (2 페이지), 기능 설명서 (4 페이지), 사용자 설명서 (9 페이지)
페이지 인쇄
• Lift the fuser up and out.
The Pro665 style comes out the same way except that you first need to remove the
front and rear covers so that you can access the front and rear plugs (for the rear plug; you
will actually go to the rear of the machine to disconnect it).
The 7042 works the same way as the Pro665 style (remove the front and rear covers
first) except that it has two rear connectors (CN11 & CN12). You will need to disconnect
both of them where they plug into the Driver Board. The front connector is CN101 which
plugs into the Low Voltage Power Supply (LVPS).
DISASSEMBLY:
1)
Flip the fuser over and remove
the bottom cover, which is as simple as
releasing a pair of clips (one at the front
end and one at the rear end).
3.) Now with the lamp out and in a safe place,
turn the assembly right side up again and
remove the top cover (2 screws and lift it off).
Take notice of the layout of the gears as the 3
idler gears are not captive and will fall off
easily.
2.)
Release the Fuser Lamp Rear Terminal's screw
to disengage the rear terminal. You can slide the Fuser
Heat Lamp out through the front end (the end opposite
the gears).