Xerox ColorQube 9203 빠른 매뉴얼 - 페이지 31
{카테고리_이름} Xerox ColorQube 9203에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox ColorQube 9203 33 페이지. Mfp
Xerox ColorQube 9203에 대해서도 마찬가지입니다: 설치 및 작동 지침 (14 페이지), 평가자 매뉴얼 (28 페이지), 빠른 사용 설명서 (38 페이지), 빠른 매뉴얼 (8 페이지), 빠른 매뉴얼 (16 페이지), 안전한 설치 및 운영 (12 페이지), 안전한 설치 및 운영 (12 페이지), 사본을 만드는 방법 (9 페이지)
페이지 인쇄
Ink Cracking
INK CRACKING
Scoring and Folding – Scoring and folding should be
done with the grain of the media in order to prevent paper
or ink from cracking (this is similar to grain considerations
with traditional printing and finishing).
The test files printed by the Xerox ColorQube 9203 were
used specifically by BERTL for evaluating its numerous
spot colors or solids. The best test for ink cracking is with
a densely covered sheet. The most creative marketing
materials that require folding utilize heavy coverage.
These particular sheets were folded and scored in both
directions and there was no more or less cracking on either
fold – inside or outside. They were printed on 220 gsm
media.
The photos to the right are examples of what used to be
problems when producing booklets with heavy coverage.
Normally, designs gave way to the shredded edges that
were synonymous with heavy ink on the spine of a booklet.
Test Results: Prints produced by the Xerox ColorQube
9203 can be folded with a slight ink cracking using heavier
weight stocks. In all the BERTL tests performed for ink
cracking the ColorQube 9203 performed admirably.
BERTL's benchmark test of printing 100% solids on 220
gsm media, and then scoring and folding the printed pages
reveals how well a device can handle the challenge of ink
cracking. Again, the Xerox ColorQube 9203 was able to
fold with minimal cracking.
Copyright © 2009 BERTL Inc.
All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further transmission of any portion of this document. This
document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any reproduction of trademarks is strictly
prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.
BERTL Analysts also ran a Temperature Adhesive Test to
see if the output generated by the Xerox ColorQube would
fuse
togerher
under
extreme
BERTL's evaluation, several full bleed pages were printed
and left on the dashboard of a car with temperatures in the
car as high as 101 degrees over a period of 9 hours.
During this evaluation, none of the pages left on the
dashboard stuck together, nor did they curled, or
experience any toner scratching off or flacking.
September 2009
Xerox ColorQube 9203
www.BERTL.com
temperatures.
During
September 2009
Page 31