Xerox Document Centre 470 ST 빠른 설치 매뉴얼 - 페이지 38

{카테고리_이름} Xerox Document Centre 470 ST에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Document Centre 470 ST 38 페이지.

Port 9100 TCP/IP Printing Quick Install Card

Xerox Document Centre 460/470 ST

Set the Subnet Mask and Gateway.

Press the Subnet and Gateway

button.

Press the soft buttons on the Touch

Screen one at a time for each octet of

the Subnet Mask and enter the

numbers using the keypad. Repeat

this process for the IP Gateway

address. When finished press Save to

record the changes and exit to the

TCP/IP Settings screen.

NOTE: The Broadcast Address will be calcu-

lated automatically.

Enable Port 9100 printing .

Press the Port 9100 printing button.

At the next screen press Enable then

press Save.

Exit the Tools Menu

Press the Exit Tools button.

Go to a workstation and...

Create a test job and send it to the printer

with a workstation utility or through a

queue on your operating system that sup-

ports Port 9100 printing.

Check your test job for quality and use the

problem solving section of the Document

Centre 460/470 Reference Guide for

resolving print defects.

If your print job does not print, refer to the

troubleshooting section in the document

entitled Network Installation and

Troubleshooting Guide to correct the

problem.

Repeat this Go to a workstation and...

procedure at each workstation that will

print to this printer or at other servers

where a queue has been created.

Page 2