Xerox Regal 5790 참조 매뉴얼 - 페이지 19
{카테고리_이름} Xerox Regal 5790에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Regal 5790 44 페이지. Digital color copier/printer materials usage guide
Xerox Regal 5790에 대해서도 마찬가지입니다: 보충 설명서 (1 페이지), 참조 매뉴얼 (7 페이지), 참조 매뉴얼 (7 페이지), 시작하기 매뉴얼 (46 페이지), 참조 매뉴얼 (18 페이지), 사양 (7 페이지)
페이지 인쇄
REGAL 5790 MATERIALS USAGE GUIDE
down will minimize this condition. Your Xerox Service
Representative can also demonstrate cleaning procedures to
minimize this condition.
•
Two-sided copying of coated papers is not recommended.
Paper curl created when running side 1 can cause a high jam
rate with side 2. If this occurs, flipping the paper over for side 1
may improve curl and feeding performance. Manually curling
the lead edge of the side 1 imaged sheets down before loading
them for side 2 can also improve side 2 feeding. Image quality
on side 2 will also be reduced with certain images. Light image
patches (mottle) and deletions are likely on side 2 especially in
large halftone areas. Areas of variable image gloss will also
occur on side 1 during the 2nd pass. This will be most evident
on large solid areas. Running the image with the lowest area
coverage on side 1 will minimize this condition. Over time, this
image gloss variation will improve if the oil on the copies is
allowed to evaporate.
•
Toner saturation on electronic originals should be limited to a
total of 280% (70% for each Color). Higher toner saturation can
result in poorly fused prints.
•
James River King James Cast Coat 8pt. has a high gloss
coating on one side and a large natural curl. The large curl
allows this extra heavy (172 gsm) material to run reliably. This
material must be run curl down from the bypass with the 8.5 inch
edge as the leading edge.
•
If using a coated paper that has not been mentioned, first try a
small quantity to test its performance, then consult your local
Xerox representative for agreement on its use.
USAGE GUIDELINES
15