Xerox Regal 5790 참조 매뉴얼 - 페이지 28

{카테고리_이름} Xerox Regal 5790에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Regal 5790 44 페이지. Digital color copier/printer materials usage guide
Xerox Regal 5790에 대해서도 마찬가지입니다: 보충 설명서 (1 페이지), 참조 매뉴얼 (7 페이지), 참조 매뉴얼 (7 페이지), 시작하기 매뉴얼 (46 페이지), 참조 매뉴얼 (18 페이지), 사양 (7 페이지)

페이지 인쇄

APPLICATIONS

8 When running large jobs of more than 25 copies, split the job into

multiple groups of 25 sheets maximum. That is, run 25 copies of

side 1, then run 25 copies of side 2.

9 Heavy-weight papers (greater than 28 lb bond (105 gsm), coated

papers, and transparencies should not be used for two-sided

copying. Frequent jams and image quality problems are likely

with heavy-weight and coated papers. Duplexing of

transparencies will cause damage to the copier/printer.

Hints, Tips & Testing Results

Xerox testing has shown the following:

•

All color copiers/printers experience a higher jam rate when

performing duplex copying. Paper jams can be caused by the

curl created when running the side 1 image. This unpredictable

side 1 curl is the main reason that heavy-weight and coated

papers cannot be recommended for two-sided copying.

•

Another cause of increased jams is the contamination of the

feed rolls with fuser oil when running a large number of duplex

copies. This contamination may require more frequent cleaning

of the rollers. Your Xerox representative can give you

information on performing these cleaning procedures (order

number 700P98965). To help reduce this contamination

problem, and improve feeding reliability, mix one-sided copying

jobs with two-sided copying jobs when possible. During large

Duplex jobs, periodically run 5 blank sheets from the Paper Tray

Bypass in the Black Mode to help keep the feed rolls clean.

•

Image quality on side 2 will usually be equal to the side 1 image,

but is more likely to have image mottle/light area problems

caused by slight waviness in the paper and variable toner

transfer. Both of these factors are greatly influenced by the

paper's quality. This is another reason that heavy-weight and

coated papers are not recommended for duplexing.

•

Most two-sided copying can be done using the Standard Side 1

or 2 button on the Paper Type (Bypass) sceen. To make

Duplex copies with this method:

Copy the first side from any paper source using the basic

procedures for normal copying.

Load the side 1 imaged sheets in the Paper Tray Bypass. (Use

steps 6 through 9 from the Steps for Success section.)

Select the Standard Side 1 or 2 button on the Paper Type

(Bypass) screen, if it is not already selected as the default

setting. Then run side 2.

If you experience a high jam rate or are not satisfied with the

image quality, use the Special method of two-sided copying.

REGAL 5790 MATERIALS USAGE GUIDE