Xerox WorkCentre 238 보충 설명서 - 페이지 5

{카테고리_이름} Xerox WorkCentre 238에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WorkCentre 238 20 페이지. Xerox multifunction printers detailed specifications
Xerox WorkCentre 238에 대해서도 마찬가지입니다: 참조 매뉴얼 (27 페이지), 사양 (21 페이지), 평가자 매뉴얼 (27 페이지)

페이지 인쇄

Setup

This chapter describes:

– how to load tab stock into the paper trays

– how to create tab masters

Loading tab stock into the paper trays

This procedure is the same for both copying and printing onto tab stock.

Note:

– tab stock can be loaded into either the Bypass Tray, Tray 1 or Tray 2.

– The stock you are using for the body of the document should be loaded into

– The tab stock and the body stock MUST be the same size and orientation.

Bypass Tray

Load the tab stock into the bypass tray as

follows:

a) Tabs to the left with tab 1 on top and at

b) Tabs in standard order. If more than

Move the rear guide against the rear edge

of the tab stock.

Xerox CopyCentre, WorkCentre, WorkCentre Pro 232/238/245/255/265/275 Tab Supplement

Trays 3 or 4.

Use 8.5 x 11 inch paper with 9 x 11 inch tab stock or A4 paper with A4 tab

stock in the same orientation.

the front of the tray

one set of tabs is required, the number

and sequence of the tabs loaded must

match the number and sequence of

tabs to be printed. Any surplus tabs

should be removed from each set prior

to starting the job.