Xerox WORKCENTRE 5775 시작하기 매뉴얼 - 페이지 15

{카테고리_이름} Xerox WORKCENTRE 5775에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WORKCENTRE 5775 32 페이지. Smart card
Xerox WORKCENTRE 5775에 대해서도 마찬가지입니다: 정보 매뉴얼 (50 페이지), 평가자 매뉴얼 (24 페이지), 데이터시트 (18 페이지), 정보 시트 (8 페이지), 안전한 설치 및 운영 (11 페이지), 사용자 지침 (5 페이지), 사용자 설명서 (8 페이지), 사본을 만드는 방법 (10 페이지), 설치 매뉴얼 (43 페이지)

Making Copies

Load your documents face up in the document feeder input tray. Adjust the guide to just touch the

documents.

Or...........

Lift up the document feeder. Place the document face down onto the document glass and register

it to the arrow at the top right rear corner. Close the document feeder.

Press the Clear All (AC) button once to cancel any previous screen programing selections.

Press the Services Home button and select the Copy

option.

The Copy features are displayed.

Select the required features using the touch screen:

Reduce / Enlarge can be used to reduce or enlarge the image by 25% to 400%.

Paper Supply is used to select the required tray and size of paper for the copy output.

2-Sided Copy is used to produce 1 or 2-sided copy output.

Copy Output is used to select collate, staple or fold options (depending on the finishing

device available).

Enter the copy quantity using the numeric keypad and press Start to scan the originals.

Remove the originals from the document feeder or document glass when scanning has completed.

Note:

The Copy job enters the job list ready for printing.

Select Job Status to view the job list and check the status of your job.

If your job is held in the list it requires additional resources to print. To identify the resources

required, select the job and select Job Details. Once the resources are available the job will print.

For information about additional Copy features, refer to

For information about copying an ID card, refer to

Copy Options

Copying an ID Card

WorkCentre™ 5735/5740/5745/5755/5765/5775/5790

Making Copies

on page 44 of Copy.

on page 204 of

ID Card

Getting Started

Copy.