Xerox WorkCentre Pro 232 보충 설명서 - 페이지 6
{카테고리_이름} Xerox WorkCentre Pro 232에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WorkCentre Pro 232 20 페이지. Xerox multifunction printers detailed specifications
Xerox WorkCentre Pro 232에 대해서도 마찬가지입니다: 브로셔 (2 페이지), 참조 매뉴얼 (27 페이지), 사양 (21 페이지), 평가자 매뉴얼 (27 페이지)
페이지 인쇄
2 Setup
Note:
3
When the Tray Information screen appears, select Change Type and Color.
4
Select Tab Stock as the Stock Type and select Save.
5
Select Change Size.
6
Select the size of the tab, either A4 or 8.5x11 inches as appropriate and select
Save. (Select the same size as the body stock of the job.)
7
Select Confirm.
Trays 1 or 2
1
Load the tab stock into either tray 1 or
tray 2 as follows:
a) Tabs to the right
b) Tabs in reverse order, that is tab 1
c) If more than one set of tabs is
2
Adjust the paper guides to touch the side and back of the stack of tabs.
Note:
3
When the Tray Information screen appears, select Change Type and Color.
4
Select Tab Stock as the Stock Type and select Save.
5
Select Change Size.
6
Select the size of the tab page, either A4 Tab for an A4 document or 9x11 Tab
for an 8.5x11 inch document as appropriate and select Save.
7
Select Confirm.
4
Xerox CopyCentre, WorkCentre, WorkCentre Pro 232/238/245/255/265/275 Tab Supplement
It is important to ensure that the machine knows which tray contains the
tab stock as the print driver will select the tray by stock type and size.
Always select the correct Size, Color and Type after loading the stock in
the tray.
face down, on top and at the front of
the tray
required, the number and sequence
of the tabs loaded must match the
number and sequence of tabs to be
printed. Any surplus tabs should be
removed from each set prior to
starting the job.
It is important to ensure that the machine knows which tray contains the
tab stock as the print driver will select the tray by stock type and size.
Always select the correct Size, Color and Type after loading the stock in
the tray.