Xerox WorkCentre Pro 75 네트워크 설치 매뉴얼 - 페이지 11

{카테고리_이름} Xerox WorkCentre Pro 75에 대한 네트워크 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WorkCentre Pro 75 42 페이지. Pdl reference guide
Xerox WorkCentre Pro 75에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지), 사용자 설명서 (24 페이지), 시스템 관리 매뉴얼 (30 페이지), 참조 매뉴얼 (22 페이지)

페이지 인쇄

100BaseT Ethernet

Before You Connect to a 100BaseT Ethernet

Network

The printer Ethernet Interface has speed settings of

10Mbps (10 Megabits per second), 100Mbps (100

Megabits per second) and Auto (AutoSensing).

If your network has hubs or concentrators that have

Auto-Sensing enabled, it is possible that if the

printer is set to Auto, the hub/concentrator will not

arbitrate to the correct speed.

Before you connect the printer to your network, perform

the procedure in the next column on this page entitled

Go to the printer and...

Enter the Tools pathway

a) Press the Access (

b) On the keypad enter 1111 or the current

password. Press the Enter button when

finished. The Touch Screen will be used for

the remainder of the data entry, unless

instructed otherwise.

Set or Change the Ethernet speed.

a) Press the Connectivity and Network Setup

button.

b) Wait for the screen to refresh and press the

Physical Media button.

NOTE: Auto-Sensing hubs may not arbitrate cor-

rectly with the printer when Auto is selected. If

your hubs/concentrators support the 100BaseT

speed it is recommended you select 100Mbps in

Step d below. (Please be sure your Ethernet cable

is Category 5)

c) Select the desired Speed (10Mbps,

100Mbps, or Auto).

d) When finished with your changes press

Save.

Exit the Tools menu

a) Press the Exit Tools button.

NOTE: At this point the Network Controller is being

reset and initializing with the new setup. When

complete a Configuration Report will print.

b) Obtain the Configuration Report page from

your printer and verify that your settings have

been retained.

Connect your printer to the network with the

appropriate cabling.

Select the appropriate Network or Protocol Quick

Install Card and continue with the configuration.

) button.

604P14700