Xerox DocuColor 12 CP 사용자 설명서 - 페이지 13

{카테고리_이름} Xerox DocuColor 12 CP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuColor 12 CP 36 페이지. Recommended materials
Xerox DocuColor 12 CP에 대해서도 마찬가지입니다: 참조 매뉴얼 (10 페이지)

페이지 인쇄

Using the Finisher

The Finisher can staple from 2 to 50 sheets (50-sheet maximum applies to up to 24 lb/90

gsm paper). You can staple both portrait and landscape documents with single or dual

staples. Output to the Finisher Output Tray is delivered face down.

•

Jobs containing more than 50 sheets will not be stapled.

•

Paper Tray 5 cannot be selected as the paper source for a stapled job.

Refer to the "Technical data" section of this guide for complete stapling specifications.

NOTE: The procedures in this section apply to the Document Centre ColorSeries 50

copier/printer only. To use the Finisher options on the DocuColor 12 copier/printer, refer to

the product manual supplied by the manufacturer of the Digital Front End connected to

your DocuColor 12.

Stapling options

Stapling options are selected from your printer driver and depend on the paper size

selected. The table below shows the typical stapling options along with an example of the

finished output for 8.5 x 11 or A4 paper.

1 Staple Portrait

1 Staple Landscape

2 Staples Portrait, Long Edge

2 Staples Landscape, Long Edge

2 Staples Portrait, Short Edge

2 Staples Landscape, Short Edge

IN-LINE STAPLER FINISHER USER GUIDE

Printer driver selection

Table 1: Stapling options

Finished example

8.5 x 11