Xerox DocuColor 252 릴리스 노트 - 페이지 17
{카테고리_이름} Xerox DocuColor 252에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuColor 252 41 페이지. Docucolor advanced multifunction
Xerox DocuColor 252에 대해서도 마찬가지입니다: 기능 설명서 (12 페이지), 사용자 설명서 (32 페이지), 사양 (8 페이지), 평가자 매뉴얼 (14 페이지), 평가자 매뉴얼 (16 페이지)
페이지 인쇄
Page 17
Page Range
You cannot access the Page Range option from the printer driver. Use the application page
range option or change the setting for this option in Command WorkStation.
Layout (N-up Layout) and Print Page Borders
If you print an N-up job, where N is greater than 1, from the PCL printer driver, you can
control whether the borders of the pages are printed, using the Print Page Borders option.
If you print from the PostScript printer driver, page borders are always printed.
Offset Mode and Page Size
If you enable Offset Mode (Finishing tab) for your print job, do not select A5 LEF and B5
SEF as Page Size
Finishing Options
Stapler Mode and Punch Position
Stapling and punching require that a finisher is installed on the copier. The finisher type
determines the number of holes (2, 3, or 4) punched. Use the Punch Position print option to
specify the position of punching. Use the Stapler Mode print option to specify the number
(1 or 2) and position of staples.
Finishing Options on the Advanced or Professional Finisher
Neither stapling nor punching are supported for the following page sizes on the Advanced or
Professional Finisher:
4 x 6 SEF, 5 x 7 SEF, A5 SEF, A5 LEF, B5 SEF, 12 x 18 SEF, SRA3 SEF, 13 x 19 SEF
For which stapling and punching options are available for each supported page size, see the
following tables.