Xerox Phaser 8200 네트워킹 설정 매뉴얼 - 페이지 40

{카테고리_이름} Xerox Phaser 8200에 대한 네트워킹 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 8200 47 페이지. Phaser color printer
Xerox Phaser 8200에 대해서도 마찬가지입니다: 트레이 모듈 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (1 페이지), 신속한 릴리스 매뉴얼 (1 페이지), 설치 (1 페이지), 매뉴얼 (2 페이지), 사양 (4 페이지), 서비스 매뉴얼 (11 페이지)

Verify that the Primary Server is set (NetWare 3.1X only). (Primary Server should have been set

during initial queue setup and installed using CentreWare DP.) If it is not set, use CentreWare DP

to set it and reset the printer.

Note

Setting the Primary Server is extremely important on large networks.

If the above quick checks fail to fix the printing problem, refer to the Xerox web site at:

www.xerox.com/officeprinting/support.

Novell NetWare troubleshooting step-by-step

The steps in this procedure should eliminate cabling, communication, and connection problems

associated with network connected printers. The steps are divided into two groups:

Hardware Step-by-Step

Software Step-by-Step

Software Step-by-Step assumes that you are connected to a Novell NetWare network with a Windows

OS loaded on the client workstation. Complete both of these procedures, then run a test print from your

software application. If the job prints, no further system troubleshooting is necessary.

Novell NetWare hardware step-by-step

Check LED activity on the printer. Link (green) LED should be ON whenever it is connected to an

active network. Traffic (orange) LED should flicker with data reception.

VERIFY cable connections. If possible, substitute a new cable or connectors from a known good

system or printer.

Check the port to which your printer is attached. Connect a known good network device to it and

test.

Print the Configuration Pages from your printer. For information on printing Configuration Pages,

see the Front Panel chapter of the Phaser 8200 Color Printer User Guide on the

Software and Documentation CD-ROM.

Review the Connectivity Settings and check for these items:

NetWare is enabled.

Frame Type matches the frame type of the desired file server.

Note

To determine your NetWare IPX frame type, type config at the Novell console screen. On

large networks, using multiple IPX frame types, it is CRITICAL that the frame type be set

correctly.

PDL is set to your desired PDL (PostScript or PCL) or to Auto.

Primary Server (for NetWare 3.x only) is set to the name of the server which serves the print

queue you have assigned to the Phaser printer.

Phaser® 8200 Color Printer

Novell NetWare 3.x/4.x/5.x Network