Xerox Phaser 8200 네트워킹 설정 매뉴얼 - 페이지 7

{카테고리_이름} Xerox Phaser 8200에 대한 네트워킹 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 8200 47 페이지. Phaser color printer
Xerox Phaser 8200에 대해서도 마찬가지입니다: 트레이 모듈 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (1 페이지), 신속한 릴리스 매뉴얼 (1 페이지), 설치 (1 페이지), 매뉴얼 (2 페이지), 사양 (4 페이지), 서비스 매뉴얼 (11 페이지)

페이지 인쇄
Xerox Phaser 8200 네트워킹 설정 매뉴얼
PostScript Utility files can be used on hosts that do not have BOOTP or DHCP— see the ReadMe
I
file on your printer's CD-ROM. The PC ReadMe file is in the UTILS directory; the Macintosh
ReadMe file is in the Network Utilities folder.
Note
When two or more IP address methods are used simultaneously, the printer uses the first
address that it successfully obtains.
Information Required for IP Addressing
Information
Internet (IP) address for the printer
Network Mask
Default Router/Gateway address

Setting the IP address from the front panel

For information about using the front panel, refer to the Front Panel section of the Phaser 8200 Color
Printer User Guide on the Software and Documentation CD-ROM.
Note
DHCP must be set to OFF before you can set the IP address from the printer's front panel.
1.
With
highlighted, press the OK key.
Menus
2.
Press the Scroll Down key to scroll to the
3.
Press the OK key.
4.
Scroll to
TCP/IP
Address.
5.
Press the OK key.
6.
Press the Scroll Down or Scroll Up key to scroll to the correct number for the first digit of the
address, then press the OK key to accept that digit.
7.
Repeat step 6 for each remaining digit.
8.
Scroll to
TCP/IP Network Mask
9.
Press the Scroll Down or Scroll Up key to scroll to the correct number for the first digit of the
address, then press the OK key to accept that digit.
10.
Repeat step 9 for each remaining digit.
11.
Scroll to
TCP/IP Gateway
12.
Press the Scroll Down or Scroll Up key to scroll to the correct number for the first digit of the
address, then press the OK key to accept that digit.
13.
Repeat step 12 for each remaining digit.
14.
To exit the menu system, scroll to
Phaser® 8200 Color Printer
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents a decimal number
from 0 - 255.
If you are unsure, leave this blank; the printer chooses an
appropriate mask.
If you want to communicate with the printer from anywhere other
than the local network segment, you need the router address.
Network Setup
and press the OK button.
and press the OK button.
and press the OK key.
Exit
IP Address
Menu.
2