Xerox PHASER 5400 빠른 설치 매뉴얼 - 페이지 37

{카테고리_이름} Xerox PHASER 5400에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox PHASER 5400 40 페이지. 1000-sheet stacker
Xerox PHASER 5400에 대해서도 마찬가지입니다: 기술 지침 (5 페이지), 매뉴얼 (11 페이지), 설치 지침 (2 페이지), 종이 매뉴얼 (2 페이지)

페이지 인쇄
Xerox PHASER 5400 빠른 설치 매뉴얼
Dynamic addressing (DHCP)
The TCP/IP address is assigned automatically by the server.
1.
Press Menu Up or Menu Down until you see:
Menus
Ethernet Menu
2.
Press Item Up or Item Down until you see:
Ethernet Menu
IP Address Res.
3.
Press Value Up or Value Down until you see:
IP Address Res.
DHCP
4.
Press Enter.
5.
Power off the printer.
6.
Power the printer on and allow time for an IP address to be
assigned by the DHCP server (this time may vary depending on
network traffic).
7.
Perform the steps contained in the section of this document
entitled Appendix A: Print the Configuration Sheet.
8.
Obtain the TCP/IP address from the Configuration Sheet.
9.
Update the lease time, if necessary, depending on your
printer-usage patterns.
Note
If your network is using this protocol to assign TCP/IP
addresses, be aware that the lease on the assigned address
can run out if your printer is taken off the network for longer
than the allocated lease time.
Quick Network Install Guide
31