Xerox Phaser 750DP 서비스 매뉴얼 - 페이지 31
{카테고리_이름} Xerox Phaser 750DP에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 750DP 40 페이지. Digital color printer / copier
Xerox Phaser 750DP에 대해서도 마찬가지입니다: 사양 (2 페이지), 브로셔 및 사양 (4 페이지), 참조 매뉴얼 (8 페이지), 매뉴얼 (9 페이지)
페이지 인쇄
Status
Code
10-363
The control logic sensed that the Heat Roll did not return to operating temperature after a job run.
Initial action:
Ensure that the Heat Roll surface is clean (no debris, paper, etc.) (REP 5.31)
Check the Heat Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the
Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-364
The control logic sensed that the Heat Roll could not maintain temperature during a copy run.
Initial action:
Ensure that the Heat Roll surface is clean (no debris, paper, etc.) (REP 5.31)
Check the Heat Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the
Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-365
The control logic sensed that the Heat Roll did not reach operating temperature within 150 seconds after Power
Saver mode was exited.
Initial action:
Ensure that the Heat Roll surface is clean (no debris, paper, etc.) (REP 5.31)
Check the Heat Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the
Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
5750 DocuCare Service Manual
Description/Direction
5/98
2-31
Fault Code Procedures